Simply cut it on site with pliars to your required length.
Safety mesh under roofing.
Galvanised safety mesh complying with as nzs 4389 2015 for use in commercial roof applications where falling from high hazards exist.
Aush mesh safety mesh works great wnen used in conjunction with insulation blanket and foil to hold it tightly and stop it from drooping.
Complies with the requirements of australian standard as4389 1996 for safety mesh with galvanised coating grade w02z.
A hole or gap in the safety mesh allowing material to fall through a gap between the top of the roof cladding and the bottom of a toe board or infill panel for example to slide roof cladding onto the roof and working from elevated structures such as working platforms ladders or scaffolding.
Most skylights degrade with age caused by exposed sunlight over a period of time.
Welded roof safety mesh is a primary means for fall protection when persons working at heights in domestic commercial and industrial building applications and housing roof construction that use metal or timber purlins or a tested supporting member.
Also used to support underlays where spans fall outside recommended distances.
The longitudinal wires are spaced at 150mm centres with cross wires spaced at 300mm centres.
Safety wire mesh is designed to prevent falls through roofs however skylights are dangerous and have been the cause of many fatalities over the years.
Safety mesh consists of 2mm galvanised wire with a tensile strength exceeding 450 mpa.
This mesh wire provides fall protection and is made in australia from galvanised steel.
If securely fixed safety mesh provides fall protection for roof installers and offers long term protection against falling for maintenance and repair workers.
Roof safety mesh coverage.
Safety mesh does not prevent falls from the edge of a roof or through holes in a roof so it should always be used in conjunction with appropriate edge protection guard rails or fall arrest systems.
It also provides a permanent safe working environment under skylights and clear composition roofing.
Steel mesh roll length.
Provides fall protection for roof installers and offers long term fall protection for maintenance and repair workers.
The longitudinal wires are spaced at 150mm centres with crosswires spaced at 300mm centres.
The provision of a permanent safe working environment throughout the roof installation and for future maintenance work can be achieved by using the safety mesh system over the entire roof plane.
3 9 roof safety mesh steel wire mesh comprising longitudinal and transverse wires fixed to an appropriate roof member to prevent persons from falling during installation of roofing materials and support insulation materials.
C3 9 roof safety mesh is intended to control the risk of fall hazards over the entire.
If your skylights have safety wire mesh installed you need to be asking yourself these three questions.
